74 Setting the ESC/P Mode
[Left -> Right]
Performs 2 Pages Up. This prints the first page of your document on the left or top
half of a page.
[Right -> Left]
Performs 2 Pages Up. This prints the first page of your document on the right or
bottom half of a page.
Important: When the orientation of [Document Size] is set to landscape, [Left -> Right]
and [Right -> Left] derive the same print result.
Tray1-Wait User
This feature allows you to request bypass printing and manually start printing by
pressing the <OK/Eject> button on the control panel. Set whether or not to enable
this feature by selecting [On] or [Off] (default).
Font
Alphanumeric
Sets the font for single-byte characters (ANK) to [Roman] (default) or [Sans Serif].
NOTE: This setting is not affected by extension commands sent from users.
Reference: "About Fonts" (P. 65)
Page Position
Sets the paper position by enabling or disabling the cut sheet feeder setting.
The following options are available:
[CSF Off] (default)
Disables the cut sheet feeder setting.
[CSF On]
Enables the cut sheet feeder setting.
Adjust Position
This feature allows you to adjust the printable area in vertical or horizontal direction
and move the margins.
Up/Down Adj
Adjusts the position of the printable area in vertical direction. The position can be
adjusted within the range of -250 to 250 mm in increments of 1 mm. The default is
[0mm].
If entering the value in inches, enter it within -9.8 to 9.8" in increments of 0.1". The
default is [0.0"].
Left/Right Adj
Adjusts the position of the printable area in horizontal direction. The position can be
adjusted within the range of -250 to 250 mm in increments of 1 mm. The default is
[0mm].
If entering the value in inches, enter it within -9.8 to 9.8" in increments of 0.1". The
default is [0.0"].
To Next Page
Loading...
Need help?
General