Phaser® 8560/8860 Printer
A-3
Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements. These
include safety agency examination, approval, and compliance with established environmental
standards.
Your attention to the following safety guidelines helps to ensure the continued, safe operation
of your printer.
Printer Location
■ Place the printer in a dust-free area within a temperature range of 50° F to 90° F (10° C to
32° C) and a relative humidity range of 10 percent to 80 percent.
■ Place the printer in an area where there is adequate space for ventilation, operation, and
servicing.
■ Do not place the printer on a carpeted floor. Airborne carpet fibers can be pulled into the
printer and cause print-quality problems.
■ Do not place the printer near a heat source.
■ Do not place the printer in direct sunlight to avoid exposure to light-sensitive components.
■ Do not place the printer where it is directly exposed to the cold air flow from an air
conditioning system.
■ Do not place the printer on a file cabinet. Closing file cabinet drawers causes jarring and
can create light stripes in prints.
Printer Clearance
The recommended minimal spacing is:
■ 20.00 cm (7.5 in.) above the printer
■ 10.16 cm (4.0 in.) behind the printer
■ 10.16 cm (4.0 in.) on the left side of the printer
■ 40.00 cm (15.5 in.) on the right side of the printer to allow access to the maintenance kit
and waste tray
Operational Guidelines
■ Do not block or cover the slots and openings on the printer. The printer can overheat
without adequate ventilation.
■ Use the printer at elevations below 2,438 m (8,000 ft.).
■ Place the printer on a level, solid, non-vibrating surface with adequate strength to hold the
weight of the printer. The base printer weight, without any packaging materials, is
approximately 28 kg (60 lb.). The printer should be within 2° horizontal with all four feet
in solid contact with the surface.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
