Loading Paper
Phaser® 8560/8860 Printer
3-20
■ Pre-punched paper: Insert the side to be printed faceup with the holes toward the
right side of the tray.
Note: When using pre-punched paper, adjust the print margins to accommodate the holes.
Printing over the holes may cause ink to transfer onto subsequent pages. A minimum
margin of 19 mm (0.75 in.) is recommended.
3. Adjust the paper guides to fit the paper loaded in the tray (if necessary).
■ Length guide: Press the sides, then slide the guide until the arrow on the guide points
to the appropriate paper size imprinted on the bottom of the tray. When properly
positioned, the guide clicks into place.
8860p-112
8860p-107
To Next Page
Loading...
