Power On or Off the Press
PPoowweerr OOnn tthhee PPrreessss
1. Check that the Main Power switch behind the Front Door is On.
2. Press the Power button on top of the press to the ON position.
The Services button glows blue.
A screen message advises of a short wait while the fuser warms up and the press runs a system
check. You can set features for a job during this time and the printing process will start
automatically when the press is ready.
PPoowweerr OOffff tthhee PPrreessss
Important: Always power off the power button first, and then power off the main power
switch.
1. Press the Power On/Off button on the top of the press to Off.
Wait until the lights on UI stop blinking, as this allows the fuser to begin cooling.
2. Switch Off the Main Power switch behind the Front Door.
Note: Allow the press to remain off for a minimum of 10 seconds before switching on the
power again.
8
Xerox
®
Versant
®
280 Press
Quick Start Guide
Getting Started
To Next Page
Loading...
