Security
Xerox
®
WorkCentre
®
6655 Color Multifunction Printer 91
System Administrator Guide
Enabling FIPS 140 Mode and Checking for Compliance
1. In CentreWare Internet Services, click Properties>Security>Encryption.
2. Click FIPS 140-2.
3. Click Enable.
4. Click Run Configuration Check and Apply.
A pass or fail message appears:
− If the configuration check passes, click Reboot Machine to save and restart the printer.
− If the configuration check fails, the reasons for the failed test list in a table at the bottom of
the page. For each reason, a link is provided. Click the appropriate link to disable the protocol,
replace the certificate, or allow the printer to use the non-compliant protocol.
Note: When FIPS 140 Mode is enabled, only FIPS-compliant certificates can be installed on the
printer.
To Next Page
Loading...
