Xerox WorkCentre PE16 - Page 62

5-22
Disassembly and Reassembly
Service Manual
July 2003 WorkCentre PE16
5.18 Pick-Up Ass'y & Solenoid
1. Before you remove the Pick-Up Ass'y, you should
remove:
- Rear Cover (see page 5-2)
- Side Cover (LH, RH) (see page 5-3)
- Front Cover (see page 5-4)
- Scanner Ass’y (see page 5-5)
- Middle Cover (see page 5-11)
- Engine Shield Ass,y (see page 5-12)
- Drive Ass’y (see page 5-18)
2. Remove the three screws securing the Feed Bracket
and remove it.
3. Remove the Pick-Up Gear Ass,y.
4. Take out the Pick-Up Ass'y, as shown below.
5. Remove the two screws securing the Manual
Solenoid and Pick-Up Solenoid. Then remove Manual
Solenoid and Pick-Up Solenoid.
Feed Bracket
1
2
Bush
Pick up Gear
Ass’y
(Pick up)
Solenoid
(Manual)
Solenoid