Xilinx Alveo U250 Getting Started

• Alveo U280 Product Page
5. Install the XRT installaon package by running the following command from within the
directory where the installaon packages reside. <version> is the laer part of the
installaon package le name.
$ sudo yum install ./xrt_<version>.rpm
This will install the XRT and its necessary dependencies. Follow the instrucons when
prompted throughout the installaon.
6. Install the deployment plaorm installaon package:
$ sudo yum install ./xilinx-<card>-<version>.rpm
The deployment soware sources are now installed on the system. The installaon of the
drivers, runme soware, and ulies are in the /opt/xilinx/ directory and contains the
xrt and dsa sub-directories. The dsa folder contains the deployment plaorm installaon.
Aer installing the deployment plaorm you will see the following message:
DSA package installed successfully.
Please flash card manually by running below command:
sudo /opt/xilinx/xrt/bin/xbmgmt flash --update --shell <shell_name>
Note: When installing 2019.1 or earlier deployment plaorm packages, the displayed instrucons use
the xbutil rather than the xbmgmt command to ash. Flashing with xbutil is being deprecated and
will not be supported in future releases. It is recommended to use the xbmgmt command to ash the
Alveo card.
7. Flash the rmware to the Alveo card using the command displayed in the output of the
previous step. It has the following format:
sudo /opt/xilinx/xrt/bin/xbmgmt flash --update --shell <shell_name>
If you have mulple cards installed or need to regenerate the command, follow the steps
given in the related topic Generang the xbmgmt ash --update Command.
8. You will be asked to conrm the update, as shown below. Type y and press the Enter key.
Status: shell needs updating
Current shell: <current_platform_name>
Shell to be flashed: <platform_to_be_flashed>
Are you sure you wish to proceed? [y/n]:
Flashing will take up to 10 minutes.
IMPORTANT! Do not enter Ctrl + c in the terminal while the rmware is ashing as this can cause the card to
become inoperable.
IMPORTANT! N'entrez pas Ctrl + c dans le terminal lorsque le micrologiciel clignote, car cela pourrait rendre la
carte inulisable.
WICHTIG! Geben Sie im Terminal nicht Strg + c ein, während die Firmware blinkt, da dies dazu führen kann,
dass die Karte nicht mehr funkoniert.
Chapter 4: Installing the Deployment Software
UG1301 (v1.5) June 3, 2020 www.xilinx.com
Getting Started with Alveo Accelerator Cards 22
Send Feedback

Xilinx Alveo U250 Specifications

General

Brand	Xilinx
Model	Alveo U250
Category	Computer Hardware
Language	English