Xilinx Alveo U250

Successfully ashing a new card results in a message similar to the one shown below. If the
command returns Card Not Found, perform a cold reboot, and retry. Otherwise, see
Chapter 7: Troubleshoong.
Updating SC firmware on card[0000:65:00.0]
INFO: found 4 sections
.....................................
INFO: Loading new firmware on SC
Updating shell on card[0000:65:00.0]
INFO: ***Found 700 ELA Records
Idcode byte[0] ff
Idcode byte[1] 20
Idcode byte[2] bb
Idcode byte[3] 21
Idcode byte[4] 10
Enabled bitstream guard. Bitstream will not be loaded until flashing is
finished.
Erasing flash...................................
Programming flash...................................
Cleared bitstream guard. Bitstream now active.
Successfully flashed Card[0]
1 Card(s) flashed successfully.
Cold reboot machine to load the new image on card(s).
If you have previously upgraded the card, you will see a message similar to the following:
Probing card[0]: Shell on FPGA is up-to-date
0 Card(s) flashed successfully.
9. Cold boot your machine to load the new rmware image on the FPGA.
IMPORTANT! Be sure to fully power o the machine and then power it on again. The image will not boot from
ash if the machine is only rebooted.
IMPORTANT! Assurez-vous d'éteindre complètement la machine, puis de la rallumer. L'image ash ne
démarrera pas si la machine n'est pas redémarrée.
WICHTIG! Schalten Sie das Gerät vollständig aus und wieder ein. Das Image startet nicht von Flash, wenn der
Computer nur neu gestartet wird.
The installaon for deployment is now complete. You can go directly to Chapter 5: Card Bring-Up
and Validaon to validate the installaon.
Related Informaon
Creang a Vault Repository for CentOS
Generang the xbmgmt ash --update Command
Chapter 4: Installing the Deployment Software
UG1301 (v1.5) June 3, 2020 www.xilinx.com
Getting Started with Alveo Accelerator Cards 23
Send Feedback