Chapter 3: Getting Started with the Base Targeted Reference Design
34 www.xilinx.com ZC702 and ZVIK Getting Started Guide
UG926 (v6.0) December 17, 2013
5. The Qt-based application allows the user to experience the Base TRD video
demonstration and is controlled through the mouse. The user can click Help for short
messages and information about the control window of the QT application. The GUI can
be minimized with the MIN button (See Figure 3-6) and can be brought back to the
original size with the MAX button. The user can also control transparency of the GUI with
the Transparency slider.
6. Click Enable Video to start the internal Test Pattern Generator (TPG), which displays on
the monitor.
7. Exercise different options by pressing the buttons available in the GUI to evaluate the
different use cases mentioned in Table 3-1.
X-Ref Target - Figure 3-7
Figure 3-7: Minimized GUI Mode
Table 3-1: Zynq-7000 AP SoC Base TRD Video Demonstration Use Cases
Use Case Video Source Control Sobel Filter Control
1 TPG interference Sobel OFF
2 TPG interference Sobel - SW
3 TPG interference Sobel - HW
Additional ZVIK Options
4 External video Sobel OFF
5 External video Sobel - SW
6 External video Sobel - HW
To Next Page
Loading...
Need help?
General
