gain parameters at the exit time. If auto-tuning fails, it is necessary to initialize the driver before
auto-tuning again.
◼ Panel alarm in auto-tuning process
Failure to search for optimal gain
Too large inertia ratio; too weak rigidity of
mechanism
Overtrip alarm in auto-tuning process
Please make sure that there is no overrun
and alarm before auto-tuning.
Driver is not in "bb" state at the time of
operation
Please make sure the present status of
driver
Driver alarmed in auto-tuning process
XinJeServo software auto-tuning steps
1. click auto-tuning on the XinJeServo software main interface
2. set the auto-tuning trip in jog mode or manually
tudonghoatoancau.com
To Next Page
Loading...
Need help?
General
