XOR electronics Nerdseq - More Video-IO

To Next Page

To Previous Page

So the input settings can be from 1 up to 6 CV notes polyphonic or 1 to 5 CV notes plus the

Envelope. All these are filled in to the CV16 columns. If the envelope function is activated for it,

then also Envelope #8 is used. When multiple keys are pressed, the envelope will run through

Attack→Sustain on the first note and starts the release phase when releasing the last note.

Another setting is the 2x2 or 3x3 polyphonic recording. In this mode a 2 or 3 voice polyphonic

recording and envelope generation is possible. In case of the 2x2 mode, up to 2 notes at the same

time will be entered in the first 2 columns, while the next 2 columns set the envelopes for these

notes. So Column 3 envelope is for Note 1 in column 1 and Column 4 envelope is for Note 2 on

column 2. If the 3x3 mode is active, then it records up to 3 notes + each an envelope, where the

first 3 columns are the notes and the next 3 columns the envelopes for the corresponding notes. It

is possible to get full 3 voice polyphony with this per track.

Please keep in mind that the Glide, Envelopes and LFO can never fully replace real analogue

Slews, Envelopes or LFO’s. But they are definitely a very good addition for many applications.