Remove the current row and shift everything below the row one up: SHIFT+UP+DELETE
Insert an empty row and shift everything below the current row one down:
SHIFT+DOWN+DELETE
You can browse between different patterns by holding the PATTERN button and using the cursor
keys. This will navigate between the patterns as they are arranged on the → Sequencer Screen.
PATTERN + CURSOR LEFT/RIGHT will browse through the sequencer row/tracks and select any
available pattern there to be edited directly. And PATTERN + CURSOR UP/DOWN will browse
through the patterns on the same track as they are lined up in the sequencer screen.
If on a FX command, you can open the FX Selector by pressing the OK button.
A menu appears with a selection of all possible ‘effects’ for this track type. You select an effect with
the OK button and it will be filled in into the FX command column.
There are several facilities to copy or delete pattern content. For that there are the 3 Buttons Mark,
Copy and Delete.
Mark to mark an area which should be copied or deleted (use SHIFT+DOWN to mark all), Copy to
copy/insert a before copied area to another row/column and Delete to empty or delete the marked
area (or to delete/empty the recent cursor position). A delete will also copy the deleted values to
the clipboard, so it is possible to use it as a Cut + Paste function.
To Copy a block:
Press SHIFT+MARK on the first position which should be copied (Screen border colour should
change to indicate the Mark mode)
Move the cursor to the last position of the desired area ( Press SHIFT+DOWN to mark all )
The start position of the mark can be changed when holding the SHIFT button when navigating.
Press SHIFT+MARK again. Mark mode is released again, the marked block is being saved.
Now go to the Destination position with the Cursor.
there are 2 possibilities to copy.
1
st
Press SHIFT+COPY and the before saved block is being copied to the current position.
(Overwrites content of the Block)
2
nd
Press SHIFT+DOWN (Not cursor down)+COPY and the before saved block is being inserted to
the current position. The involved rows will move down behind the copied/inserted area.
You can also copy in between different patterns and from/to compatible column types (eg from
notes to notes...)
NerdSEQ – a tracker based Eurorack sequencer Page 62
User Manual Revision V1.26 for Firmware V1.26 12 July 2022
To Next Page
Loading...