The destinations in the modulation matrix for the ‘More Triggers 16’ expander assigned tracks are:
• Trigger 1..4 Length → Overrules the next trigger (trigger of the expander) setting where the
length of the trigger is decided by the Automator output (10 .. F0)
• Delayed Trigger/Gate 1..4 length → overrules the next trigger (of the expander) setting with
a OFF/ON trigger / gate where the length of the delay is decided by the Automator output
(01 .. 0F)
• Triggers Galore → Sends triggers (the triggers are as set up in track setup) to the trigger
outputs of the current position of the Automator output.
• Triggers Square 8 → Uses the Automator output to set and reset Trigger output 8 (or 16 if
swapped). If the Automator output is higher than 0 then the output is being set and if lower
0 than the output is reset. Only applies to outputs 8 or 16!
• The rest are the same as a regular CV/Gate track, except for that the probabilities are set to
the trigger output groups.
The destinations for the CV16 tracks are:
• CV 1..16 → Modulates the function onto the CV outputs 1..16
• Column 1 Probability → Probability for Column 1 of the pattern screen
• Column 2 Probability → Probability for Column 2 of the pattern screen
• Column 3 Probability → Probability for Column 3 of the pattern screen
• Column 4 Probability → Probability for Column 4 of the pattern screen
• Column 5+6 Probability → Probability for Column 5+6 of the pattern screen
• FX1..3 Probability → Probability for the FX1..3 column
• FX1..3 Overrule → Overrules the values of the FX1..3 column
• Envelope 1..8 Attack/Sustain/Release → Modulates the envelope settings
• LFO 1..8 Type/Speed/Amplitude → Modulates the LFO settings
• Local CV → Modulates the local CV output of the track-setup
• Local MOD → Modulates the local MOD output of the track-setup
• Local Glide (CV/MOD) → Modulates the local glide settings
• Row Probability → Modulates the probability of the complete pattern row
You can change the Slot and Modulation settings by using SHIFT + LEFT/RIGHT.
Start and Stop toggle by pressing OK
Start by using SHIFT + CURSOR RIGHT
Stop by using SHIFT+ CURSOR LEFT
NerdSEQ – a tracker based Eurorack sequencer Page 76
User Manual Revision V1.26 for Firmware V1.26 12 July 2022
To Next Page
Loading...