Chapter 1 Getting Started Optional Setup Tasks 11
Optional Setup Tasks
Backing Up Files and Creating a Recovery Drive
After setting up the L10 the way you like it and installing applications, create a recovery drive on an
external USB drive. A recovery drive lets you start your tablet and access recovery and
troubleshooting tools if you encounter any issues with your Windows installation.
For more information, see Backing Up Your Files on page 38 and Restoring Your System on page
39.
Attaching the Pen Tether
The pen comes with a tether so that you can attach it to your tablet to avoid misplacing it.
1. Slip one end of the tether through the hole at the end of the pen, and pull the pen
through the loop until it is tight.
2. Slip the other end of the tether through the attach point on the tablet, then pull the pen
through the loop until it is tight.
Connecting the Tablet to an External Monitor
There is no dedicated port for an external monitor on the L10 tablet. The tablet has a USB Type-C
connector which includes a DisplayPort output capability. You need a dongle that supports USB
Type-C DisplayPort and converts it to the port necessary to attach the external monitor, which can
have one or more of the following ports: HDMI, DVI, DisplayPort, or VGA.
For instance, to connect a monitor with an HDMI port to your tablet, you need a USB Type-C
DisplayPort to HDMI output dongle.
Note: Some dongles use USB to Video conversion and these use software to enable the
external display over USB interface. Care must be taken to ensure the USB Type-C
dongle specifically supports USB Type-C DisplayPort input. Look for a dongle that
states it is plug-n-play and that no software or drivers are required.
To Next Page
Loading...
Need help?
General
