37
Rev. 1.0 31/01/2020
Access this menu to select the information to print in the header of a Data Logger on a printer:
• SIMPLE: -default setting- The device model, Serial Number and date and time of the last calibration
are printed in the header.
• COMPLETE: In addition to the information of the SIMPLE format, the calibration data are also printed
(available in the "CALIBRATION DATA" setup menus).
Note: The header is printed in the following cases:
• When a printout of values for a certain parameter is started for the first time
• When a new calibration is performed
• Example of automatic Data Logger mode
Example: automatic pH recording on internal memory every 2 minutes
• Access the LOG SETTING P8.0 setup menu.
• Enter the LOG TYPE P8.1 menu, press and move with directional keys to MINUTES.
• Use the directional keys to change the number that flashes on the display. Enter "2" and confirm with
.
Go back to measure mode and go to the pH screen .
The icon is lit in the lower string of the display, which indicates that an automatic frequency Data
Logger has been set. Press to start recording; the icon starts flashing, indicating that the
storage is in progress. The number next to the M+ icon indicates how much data has been saved for
that parameter.
Press again to end the recording.
Note: automatic recording is suspended when the measurement parameter is changed.
• Example of manual Data Logger mode
Example: recording a Conductivity value in manual mode
• Access the LOG SETTING P8.0 setup menu.
• Enter the LOG TYPE P8.1 menu, press key and move with the directional keys to MANUAL.
• Confirm with and return to measure mode, go to the COND screen .
Press to save the value. The number next to the M+ icon indicates how much data has been saved
for that parameter.
Note: Manual or automatic saving of a value is confirmed by a sequence of flashes of the green LED
• Example of printing a value
Example: manual printing of a pH value with calibration data too
• Access the LOG SETTING P8.0 setup menu.
• Enter the LOG TYPE P8.1 menu, press and move with the directional keys to MANUAL. Confirm
with .
To Next Page
Loading...
Need help?
General
