39
Rev. 1.0 31/01/2020
* Function available for PC 60 VioLab only
P9.1 Temperature Unit
Access this setup menu to select the temperature unit to use.
• °C -default-
• °F
P9.2 Date and time setting
Access this setup menu to update the device date and time.
Use the directional keys to change the year, confirm with and repeat the same operation for month,
day, hours and minutes.
IMPORTANT: Date and time and all GLP data are kept even in case of sudden power failure
P9.4 Brightness
Access this setup menu to choose between three different levels of display brightness.
• LOW – low
• MEDIUM – medium
• HIGH – high
P9.6 Select Parameters
Function available only for PC 60 VioLab
Through this setup menu, it is possible to select which parameters do NOT display in measure mode.
Access menu P9.6. The icon flashes, with directional keys choose:
• YES: in measure mode the pH parameter is kept active
• NO: in measure mode the pH parameter is not displayed
Confirm the selection with key ; now the icon flashes, then repeat the same operation for
the mV parameter and then for all the parameters up to TDS .
Example: The user wishes to work with pH, Conductivity and TDS parameters only.
In the P9.6 menu:
pH -> YES / mV -> NO / ORP -> NO / COND -> YES / TDS -> YES
Press twice key to return to measure mode. Scrolling with the key only the parameters pH, COND
and TDS are shown.
Note:
At least one of all the parameters must be enabled with YES
P9.8 Reset Settings
Access this setup menu to restore the instrument to factory conditions.
IMPORTANT: Restoring the factory parameters does not delete the stored data
To Next Page
Loading...
Need help?
General
