FS4.0e Elliptical
3
WARNING!
• NEVER remove any cover without rst disconnecting AC
power supply.
• If A.C. voltage varies by ten percent (10%) or more, the performance
of your elliptical may be affected. Such conditions are not covered
under your warranty. If you suspect the voltage is low, contact your
local power company or a licensed electrician for proper testing.
• NEVER expose this elliptical to rain or moisture. This product is NOT
designed for use outdoors, near a pool or spa, or in any other high
humidity environment. Maximum environmental ratings are 40-120
degrees Fahrenheit, 95% humidity non-condensing (no water drop-
lets forming on surfaces).
• NEVER operate this elliptical without reading and completely understanding the results of
any operational change you request from the computer.
• Understand that changes in resistance do not occur immediately. Set your desired level on
the computer console and release the adjustment key. The computer will obey the
command gradually.
• NEVER use your elliptical during an electrical storm. Surges may occur in your household
power supply that could damage elliptical components.
• Use caution while participating in other activities while using your elliptical such as
watching television, reading, etc. These distractions may cause you to lose balance,
resulting in serious injury.
• Always hold on to a handlebar while making control changes.
Important Electrical Instructions
Important Operation Instructions
The elliptical is equipped with transport wheels, which are engaged when the rear of the
elliptical is lifted.
Transportation
Plug-In
This product is preset to a DISPLAY MODE that keeps the console continually powered on. To
turn this feature off and allow your display to go into SLEEP MODE when not being used, please
use the following procedure:
1. When in stand-by status, hold Start, Stop and Enter keys for ve seconds to enter the Engi-
neering Mode.
2. Use the 5/6 keys to choose SELECT FUNCTION, then press the ENTER key.
3. Use the 5/6 keys to select the SLEEP MODE, then press Enter key.
4. Use the 5/6 keys to turn ON or OFF the sleep mode function.
5. Hold the Stop key to save and exit Engineering Mode.
Exiting Display Mode
To Next Page
Loading...
Need help?
General
