complete the self-learning of the gearbox and improve the
quality of shifting.
After the engine ECU, crankshaft position sensor, or
crankshaft flywheel is replaced, or the DTC 'gear not learned'
is present, gear learning must be performed.
The operation guidelines of the Gear learning function are
shown as below:
1. Enter the Gear learning menu and choose relevant
models according to the vehicle being tested.
2. Turn on the ignition switch to start the vehicle.
3. Enter the Tooth Learning menu.
Read carefully and complete the requisites listed before
performing the gear learning function. And press OK after
completing the instructions shown
To Next Page
Loading...
