Figure 5-26 Sample of gearbox matching function (screen 1)
5. Wait until the message ‘Successful operation’ popes up.
5.9 GEAR LEARNING
The crankshaft position sensor learns crankshaft tooth
machining tolerance and saves to the tablet to more accurately
diagnose engine misfires. If gear learning is not performed for
a car equipped with a Delphi engine, the MIL turns on after the
engine is started. The diagnostic device detects the DTC
P1336 'Gear not learned'. In this case, you must use the
diagnostic device to perform gear learning for the car. After
gear learning is successful, the MIL turns off. This function can
To Next Page
Loading...
