Xtrails VESDA VLI - Configuration; 5.1 Connecting to a Standalone VESDA VLI Detector

VESDA VLI Product Guide VESDA by Xtralis
34 www.xtralis.com
5.1.1 Creating a USB Connection
1. Open the VLI detector and connect the USBcable from the USB socket on the main board inside to a
PCor laptop located near the detector with the Xtralis VSCsoftware installed. Refer to Chapter 7 for
further information on opening the detector.
2. Follow the steps in Section 5.1.
3. Select BACnet from the Add Connection dialog box (Figure 5-2).
4. Select USB, then select Next (Figure 5-3).
Figure 5-3: Select USB
5. Select the detector type from the list of available detectors, then select Next (Figure 5-4).
Figure 5-4: Select Device
6. Accept the pre-generated BACnet Device ID number, then select Next (Figure 5-5).
Figure 5-5: Enter a BACnet ID
7. Enter a unique name for the Connection or accept the pre-generated name, then select Finish (Figure 5-6).