Xtralis XAS-2-USîProduct Guide Xtralis Pty Ltd
2.3.2 Baffles
Baffles are used to direct the sampled air flow through the point detectors. They are shaped to match a particular
model or range of detectors and simply clip into position in the slots provided in the transparent lid of the detector
housing.
Refer to Tableî3-4 on page 24 for ordering information.
2.3.3 Point Detector Installation
l Using the associated 4 inch mounting bases, a pair of conventional or analog addressable point detectors are
mounted on the display/mounting board using the screws provided.
l The terminals on the point detectors must be connected to the detector terminals located in the center of the
point detector mounts, on the underside of the mounting board. Maintain correct polarity if required by the
particular detectors being installed. Refer to manufacturers wiring instructions for details.
l The signal wiring between the point detectors and the terminal blocks in the wiring enclosure has been
completed at the factory.
14 www.xtralis.com
To Next Page