Page 74 Xtreme Manufacturing, LLC
Lockout / Tagout XR1255
Lockout/Tagout Procedure
Perform the following procedure to lockout and tagout
the forklift. This procedure, requiring a lock, and danger
tags are to be used whenever the forklift is unsafe for
operation or maintenance.
Removing Forklift From Service
1. Attach “Do Not Operate” tags to steering wheel and
ignition key.
2. Pull back on both battery cover T-handles until they
release from holders.
3. Lower battery cover.
4. Set battery disconnect switch to OFF.
5. Lock battery disconnect switch.
6. Attach “Do Not Operate” tag to battery disconnect
switch.
Figure 8-5. Battery Disconnect Switch.
Warning
If forklift is unsafe for operation or maintenance, the
defect or defects must be clearly documented and
posted in a conspicuous place on the forklift. Failure
to comply could result in death, serious injury, or
property damage.
Returning Forklift To Service
When the forklift has been repaired and made safe for
operation and maintenance, perform the following
procedure to return the forklift to service.
1. Remove lock and “Do Not Operate” tag from battery
disconnect switch.
2. Raise and secure battery cover.
3. Remove “Do Not Operate” tags from steering wheel
and ignition key.
Do Not Operate Tag.
Note: sample “Do Not Operate” tags are provided in the
back of the manual.
To Next Page
Loading...
Need help?
General
