13
3.5.2. Determination of the installation site
- Determine the place for curtain installation; exhaust of the curtain must be flush with the door frame opening
at the minimum distance from the wall (see 3.1.4. and 3.1.5.). If this is not possible, the general rule for
correct positioning and subsequent turning of the curtain (pre-blow setting) applies, i.e. the exhaust corner
of the curtain must always be at the tangent of the shielded opening. See paragraph 3.7 for further
explanations.
3.5.3. Auxiliary anchoring structures
- Prepare suitable auxiliary anchoring structures (consoles, threaded rods, etc.) depending on the weight of
the curtain, the surface into which you will anchor, and the selected suspension method (into the ceiling, in
the wall, etc.).
- Wind air curtain weight table:
3.5.4. Correct installation in horizontal position
- To allow proper rotation of the curtain - 10° towards the outside area (pre-exhaust setting) - the total
length of the hinge from the wall, on the far side of the wall, must be longer by 90 mm. The expected
lateral distance of the curtain from the wall is 100 mm.
- If the distance from the wall is larger, the curtain must rotate at a larger angle, and the hinge length must
be recalculated.
- To correctly determine the rotation angle of the curtain, the rule must be observed that the corner of the
curtain exhaust must always be tangentially to the shielded opening.
- To facilitate suspension, we recommend using simple hangers (WIND-HINGE accessories), which are attached
to the prepared threaded nuts on the side of the unit (use M6x20 screws).
USE OF ASSEMBLY HINGES (ON EACH CURTAIN USE
4
HINGES) - WIND-HINGE accessories
THREADED RODS
To Next Page
Loading...
General