4
1. General information
1.1. Introduction
- This document "Installation and Operating Manual" is intended for the Wind air curtain (hereinafter the
"curtain"), which is used to separate the interior from the external environment by a stream of air and for
hot-air heating of the required space. Detailed familiarisation with this document is important for the
correct and safe installation and functioning of the curtain. Failure to follow the conditions in this document
may result in malfunction of the unit.
- The curtain may only be installed and connected by a trained person with the appropriate authorization
to connect electrical equipment, which has available suitable tools and means. During the assembly, it is
necessary to observe all the instructions and recommendations in this manual.
- For the correct operation and long-term service life of the unit, it is necessary to prevent access to
unauthorised persons and to train operators according to this document and applicable legislative
regulations.
- The documentation must always be available at the place of installation for any service intervention. It is
forbidden to interfere in any way with the internal connection of the curtain, which does not correspond to
the instructions given in this manual. Due to the continuous development of our products, we reserve the
right to change this manual without prior notice.
1.2. Use of the unit
- The Wind air curtain is designed to separate the interior from the environment by a stream of air. This
prevents the internal air from leaking out of the internal environment to the external environment when
the doors, gates, etc...are open. Other function of the curtain when the doors or gates are closed is to heat
the internal space by hot-air heating. When purchasing accessories – filter, the curtain also serves to filter
the air in the inner environment.
- The curtain is intended mainly for entrances to industrial halls, warehouses, sports facilities, workshops,
smaller facilities and commercial premises.
- The curtain is designed for indoor covered and dry areas with ambient temperatures between 5°C and
+40°C.
- The curtain may also be used for environments with a higher non-condensing humidity corresponding to
the protection class IP54 and IP44 according to EN 60529, depending on the type of curtain. However, the
maximum allowed humidity is 80%. The curtain may also be used in corrosive environment C2 according to
EN ISO 9223. The curtain must not be operated in an environment with the risk of explosion and increased
dustiness.
- Neither the manufacturer nor the supplier is liable for damage caused by improper use of the curtain. The
risk is borne by the user alone.
- The curtain must not be operated during finishing construction activities, especially during activities that
create excessive dustiness, e.g. by grinding concrete, plasterboard, etc...
1.3. Transport, inspection of delivery and storage
- Before starting the installation and before unpacking the unit from the box, it is necessary to check for any
traces of damage on the packaging. In case of damage to the packaging, please contact your carrier.
- Check if the product ordered by you is in agreement. After unpacking, check that the unit and other
components are intact. Please report any non-conformity with the order to the supplier immediately.
If an order complaint is not made immediately after delivery, it will not be taken into account later.
- If you do not install the unit immediately after purchase, it must be stored in an indoor, non-
condensing environment at temperatures in the range of 5 to 40°C. If the product has been
transported at temperatures below 5°C, it must be stored after unpacking for at least 2 hours in the
working environment where it will be installed.
- Use adequate tools to prevent damage to the goods and to avoid health and safety risks of persons.
To Next Page
Loading...
General