60
60
60 SUBMENU SETTINGS
Before entering the submenu settings these instructions must be read
carefully to prevent incorrect settings which will cause malfunction.
All parameters can also be set during operation. Therefore different parameters in the
extended submenu should be used only by trained and qualified persons.
It is suggested stopping the HYDROVAR by pressing ▼ in the main menu during changing
parameters
61
61 PASSWORD
0000
entering password (0066 = Default) by pressing ▲ or ▼
NOTICE: If the submenu is opened with the correct password it will remain open for
a time period of 10 minutes without the need of enter the password again
to access the secondary menu.
61 PASSWORD
0066
Confirm by pressing ► and the first window of the sub
menu is shown
62
62 JOG 0.0Hz
X.XX Bar
Both current output frequency and actual value are
shown.
• By pressing ▲ or ▼ in this menu, the internal controller of the HYDROVAR is
deactivated and it changes to manual mode.
• Using the ▲ and ▼ buttons any constant speed can be set without further control to
achieve the set point!
• If this value becomes 0.00 Hz the HYDROVAR stops.
• As soon as the window is left by pressing ◄ or ►, the HYDROVAR returns to the
selected mode.
To Next Page
Loading...
Need help?
General
