FT-252 OperaTing Manual44
To send the telephone number:
1. Press and hold the
PTT
switch to continue transmitting during following steps.
A. Press the
[
p
]
or
[
q
]
key to select the DTMF Memory register (
[
d 1
]
through
[
d 9
]
)
you wish to send.
B. Press the
[
F/L
]
key momentarily to transmit the tone string.
Once the string begins, you may release the
PTT
switch, as the transmitter will
be held “on the air” until the DTMF string is completed.
You can change the DTMF Autodialer sending speed, using Set Mode Item 16:
DT
SPD
. See page 57 for details.
You can also set a longer delay between the time you press the numerical key (corre-
sponding to the DTMF memory string; with
PTT
switch pressed) and the instant when
the rst DTMF digit is sent, using Set Mode Item 15:
DT DLY
. See page 56 for details.
When you activate the ANI (Automatic Number Identication) feature during DTMF
operation, the DTMF tones stored in ANI memory will automatically be sent whenever
you press the
PTT
switch.
DTMF Operation
honbun_130313.indd 44 2013/03/13 19:48:05
To Next Page
Loading...
