Yaesu FT-252 - Specifications

FT-252 OperaTing Manual 63
General
Frequency Ranges: RX 136 - 174 MHz
TX 144 - 146 (148) MHz
Channel Steps: 5/10/12.5/15/20/25/100 kHz
Frequency Stability: ±5 ppm @ 14º to 140º F (–10° to +60° C)
Repeater Shift: ±600 kHz
Emission Type: F2 , F3
Antenna Impedance: 50

Supply Voltage: Nominal: 7.4 V DC
(Negative Ground) Operating: 5.0 ~ 10.0 V DC (EXT DC Jack)
Current Consumption: 200 mA (Receive, 200 mW output)
(Approx. @7.4 V) 70 mA (Standby, Saver Off)
25 mA (Standby, Saver On)
0.5 mA (Auto Power Off)
1.6 A (5 W TX)
Operating Temperature: –4º to 140º F (–20 °C to +60 °C)
Case Size: 2.45” (W) x 4.74” (H) x 1.52” (D) (62 x 120.5 x 38.5 mm)
(W/O knob, antenna, & belt clip)
Weight: 9.9 Oz (280 g) with FNB-124LI, antenna, and belt clip
Transmitter
RF Power Output: 5.0 W (High) / 2.0 W (Middle) / 0.5 W (Low) (@7.4 V)
Modulation Type: Variable Reactance F2, F3
Maximum Deviation: ±5.0 kHz (F2, F3)
Spurious Emission: At least 60 dB down (@ High and Middle power)
At least 40 dB down (@ Low power)
Microphone Impedance: 2 k

Receiver
Circuit Type: Direct-Conversion
Sensitivity: 0.2 µV for 12 dB SINAD (144-146 MHz)
Selectivity: 12 kHz/35 kHz (–6 dB /–60 dB)
AF Output: 800 mW @ 16

for 10 % THD (@ 7.4 V) (Internal Speaker)
Specications are subject to change without notice, and are guaranteed within the
144 MHz amateur band only. Frequency ranges and functions will vary according to
transceiver version; check with your dealer.
Specications
honbun_130314.indd 63 2013/03/14 17:47:38