Yaesu FT-252 - Reset Procedures; Microprocessor Reset Options

FT-252 OperaTing Manual52
In the event of erratic operation of the transceiver, it is possible that data on the micro-
processor may have become corrupted. While this is a highly unusual situation, the only
path to recovery may involve resetting of the microprocessor. Here’s how to do this:
1. Turn the radio off.
2. Press and hold in the
[
V/M
]
key while turning the radio on.
3. Rotate the
DIAL
knob to select one of the choices from the reset menu:
F1 SETRST
: Resets the Set (Menu) mode settings to their factory defaults.
F2 MEMRST
: Clears the Memory settings to factory defaults.
F3 MB RST
: Clears the Memory Bank Assignments.
F4 ALLRST
: Clears all memories and other settings to factory defaults.
F5 M-ONLY
: Memory only mode, VFO operation is not possible.
4. Press the
[
SET/ATS
]
key momentarily to complete the reset procedure.
The “F5” option is used for setting up the “Memory Only” mode. See page 27 for de-
tails regarding the memory Only mode.
Reset Procedures
honbun_130313.indd 52 2013/03/13 19:48:10