Table 1. Instrument and Controls (See Figure 3, Figure 4, Figure 5, Figure 6, and Figure 7) (Continued)
12 AccuSense Battery Charger (MSW025-F and
MSW030-F) Only
For lift truck equipped with the standard battery pack and on board charger, it is not
required to disconnect the battery connector before charging the battery. Connect
AC cord to a 120 volt AC outlet. This will automatically charge the batteries. The
battery charger has status indicators
Power On - Connected to AC
Abnormal Shutdown
Detection Error
Charging
Charged
Red Indicator
Red Indicator
Red Indicator
Yellow Indicator
Green Indicator
NOTE: If any of the RED indicators are flashing during the charging cycle - contact
maintenance.
Model Description
35
To Next Page
Loading...
