handle stating DO NOT OPERATE. Do not operate the
lift truck until problems are corrected.
See Checks and Inspection Procedures in the Mainte-
nance section of this manual for detailed instructions. Also
refer to Table 1 for operation and description of controls.
Checks With the Key Switch OFF
Inspect the lift truck before use and every 8 hours or daily
as described in the Maintenance section of this Operating
Manual.
Before using the lift truck, make the following checks:
• Oil level in the hydraulic tank.
• Electrolyte level and specific gravity of the battery.
• Battery weight is within the range of battery weights on
the nameplate.
• Battery panels are in place and correct spacers are
installed to limit horizontal battery movement to no more
than 1/2 inch.
• Condition of forks, carriage, chains, and mast.
• Leaks from the hydraulic system.
• Condition of wheels and tires.
WARNING
Report damage or faulty operation immediately. Do not
operate a lift truck if it is damaged or does not operate
correctly. A lift truck will only do its job when it is in
proper working order. If repairs are required, install a
tag in the operator's area stating DO NOT OPERATE
and remove the key from the key switch.
Checks With the Key Switch ON
WARNING
The operator must be aware that the lift truck can tip
over. There is a risk that the operator or someone else
can be killed or injured if trapped or hit by the truck as
it tips over.
Do not start or operate the lift truck, including any of its
functions or attachments, from any place other than the
designated operator's position. Make sure that the area
around the lift truck is clear before making any operational
Operating Procedures
39
To Next Page
Loading...
Need help?
General
