will be placed. Do not raise the load to a point below where
the load is to be placed and "jog" the load up into position.
This operation uses added energy, particularly with an
electric lift truck. Be careful not to damage or move adja-
cent loads.
2. Move forward slowly. When the load is in position for
lowering on a stack, tilt the load to a vertical position and
lower the load (if truck is equipped with tilt function).
Lower the forks just enough to remove them from under the
load. Do not lower the forks so that they will drag on the
surface under the load.
WARNING
Safe, neat stacking is one of your most important func-
tions. Know the capacity of the floors in all stacking
areas. Do not handle unstable or loosely packed loads.
3. Tilt the load forward just enough to permit smooth
removal of the forks from under the load. Carefully move
the lift truck backward to remove the forks from under the
load. Lower the forks before traveling.
Operating Procedures
50
To Next Page
Loading...
Need help?
General
