Yale SmartHome Alarm series User Manual

Via SMS
GSM/GPRS module is required
to enable SMS remote command.
Remember to change the language
setting of your mobile phone to
English before proceeding.
Please use your mobile to send the
SMS Control message. A typical
message would look like this:
“Jke_11234_11_00“ ( _ indicates
space).
The message has the following
structure:
Example: Jke_11234_11_00
Jke = SMS Kword (User define)
_ = Space
1 = Area 1
1234 = User pincode
_ = Space
11 = Command (Full arm)
_ = Space
00 = Confirm message
Notes:
1) Confirm message “00” will
cause the control panel to reply a
SMS confirmation message. Using
the example above, the confirm
message will have the structure
of “Confirmation, (SMS Kword)
(Pincode) (Command) 00”.
Using example from above, the
confirmation message will be
“Confirm, Jke 11234 11 00” .
2) If you do not wish to receive
confirmation SMS from the
control panel, please skip the
“00” at the end when sending
remote command. For example,
“Jke_11234_11”
3) If Area 2 had not been enabled,
please skip the digit in front of
the user pincode. For example,
“Jke_1234_11_00”
4) For a full list of available
commands, please see the SMS
Command Table:
Command Action
10 Disarm
11 Full Arm
510 1st Power Switch Close
520 2nd Power Switch Close
530 3rd Power Switch Close
540 4th Power Switch Close
550 5th Power Switch Close
560 6th Power Switch Close
570 7th Power Switch Close
580 8th Power Switch Close
51100 1st Power Switch Open
52100 2nd Power Switch Open
53100 3rd Power Switch Open
54100 4th Power Switch Open
55100 5th Power Switch Open
56100 6th Power Switch Open
57100 7th Power Switch Open
58100 8th Power Switch Open
18

Yale SmartHome Alarm series Specifications

General

Brand	Yale
Model	SmartHome Alarm series
Category	Security System
Language	English