4. Put additional blocks under the frame behind the drive
tires.
5. If the hydraulic system will not operate, use a hydraulic jack
under the side of the frame near the front. Make sure that the
jack has a capacity equal to at least half the weight of the lift
truck. See the Nameplate.
How to Raise the Steering Tires
(See Figure 16)
1. Apply the parking brake. Put blocks on both sides (front
and back) of the drive tires to prevent movement of the lift
truck.
2. Use a hydraulic jack to raise the steering tires. Make sure
that the jack has a capacity of at least 2/3 of the total weight
of the lift truck as shown on the Nameplate.
3. Put the jack under the steering axle or frame to raise the
lift truck. Put blocks under the frame to support the lift truck.
How to Clean a Lift Truck
CAUTION
Your lift truck may be damaged if water or cleaning
agents come in contact with electrical components. DO
NOT directly spray any electrical components, espe-
cially connectors, switches, electro-hydraulic controls,
battery area, and dash display during the cleaning proc-
ess.
Portions of your lift truck may be washed with a non-heated
pressure washer. Steam cleaning is not recommended in
most instances, as condensation may form in electrical com-
ponents causing damage or erratic behavior. For cleaning
guidelines and components to avoid, see the Periodic Main-
tenance section of the Service Manual for your lift truck.
Maintenance
109
To Next Page
Loading...
Need help?
General
