3. The inner weldments and the carriage must lower com-
pletely.
4. Raise the mast 1 m (3 ft) with a capacity load. The inner
weldments and the carriage must raise smoothly. Lower the
mast. All moving components must lower smoothly.
5. Lower the load to approximately 0.3 m (1 ft). Tilt the mast
forward and backward. The mast must tilt smoothly and both
tilt cylinders must stop evenly.
6. Check that the controls for the attachment operate the
functions of the attachment. See the symbols by each of the
controls. Make sure all of the hydraulic lines are connected
correctly and do not leak.
How to Add Fuel to the Lift Truck
WARNING
Use only 86 octane unleaded gasoline.
Stop the engine. Turn the key switch to OFF, if truck is
equipped with a key switch; or press the Power ON/OFF
button, if truck is equipped with keyless start option. The
operator must be off of the lift truck while fuel is added.
No smoking.
All fuels for internal combustion engines are very flam-
mable.
Fill the fuel tank only in a designated area with good
ventilation. Have a fire extinguisher available.
Never fill the fuel tank near an open flame or near equip-
ment that can create sparks. Never check fuel level or
check for leaks with an open flame.
Breathing fuel vapor may cause nausea, unconscious-
ness or death. Long-term exposure to gasoline vapors
may cause liver or kidney damage and cancer. Avoid
breathing vapor.
Liquefied Petroleum Gas (LPG)
WARNING
Close the fuel valve on the tank when the lift truck is not
in active use. Do not park the lift truck near heat or igni-
tion sources.
Do not store LPG tanks near heat or an open flame. For
complete instructions on the storage of LPG fuels and
the refueling of LPG tanks, refer to NFPA 58 & 505.
Maintenance
164
To Next Page
Loading...
Need help?
General
