Engine modes are set in the DSC. When one of the modes
is selected, the VSM sends a message requesting the engine
ECU to establish a set engine torque output.
Only personnel with a service or supervisor password can
change the engine mode. See User Interface, Supervisor
2200 YRM 1130 or User Interface, Service Technician
2200 YRM 1131 for procedures to change engine mode.
Operating Techniques
WARNING
Before operating the lift truck,
FASTEN YOUR SEAT BELT.
There are a number of operations,
if not performed carefully, that can
cause the lift truck to tip. If you have not read the WARN-
ING page in the front of this Operating Manual, do so
NOW. As you study the following information about how
to properly operate a lift truck, remember the WARN-
INGS.
NOTE: The lift trucks in this manual are equipped with the
Emergency Locking Retractor (ELR) style seat belt. When
the ELR seat belt is properly buckled across the operator, the
belt will permit slight operator repositioning without activating
the locking mechanism. If the truck tips, travels off a dock, or
comes to a sudden stop, the locking mechanism will be acti-
vated and hold the operator's lower torso in the seat.
Basic Operating Procedures
Many people make the mistake of thinking that operating a
lift truck is the same as driving an automobile. This is not true.
Operating Procedures
74
To Next Page
Loading...
Need help?
General
