WARNING
Do not use a steel hammer on the wheel. Use a rubber,
lead, plastic, or brass hammer to put parts together.
WARNING
Do not lubricate the tire bead with antifreeze or petro-
leum-based liquid. Vapors from these liquids can cause
an explosion during inflation or use.
WARNING
DO NOT mix brands of rubber sealing rings and tires.
Serious injury to personnel or damage to the lift truck
can occur if the rubber sealing rings are not compatible
with the tire brand.
1. Clean interior and exterior
bead area of the tire. Lubri-
cate tire beads and the
inside of the tire, up to the
tire shoulders. Apply lubri-
cant to entire underside of
the TBS or TSR. Use lubri-
cant approved by the tire
manufacturer.
NOTE: If the wheel rim width
is less than six inches, the TBS will contain one valve hole to
accommodate the needle valve. If the wheel rim width is
greater than six inches, the TBS will have two holes for the
needle valve.
One hole is centrally located and the other is offset, to ensure
the correct positioning of the valve in the valve slot. The valve
hole that is not used should be sealed with a small plastic
plug.
Maintenance
185
To Next Page
Loading...
Need help?
General
