23 En
English
TROUBLESHOOTING
ADDITIONAL
INFORMATION
■ USB
In case of a transmission error without a status message appearing in the front panel of this unit, check the connection to the USB device
(see page 11).
CD player (CD-1330)
Problem Cause Remedy
See
page
Power does not turn
on
The plug is not completely inserted. Connect the power cable firmly.
9
The receiver and the CD player are
connected incorrectly.
Check the connection with the receiver.
9
The receiver is set incorrectly. Check the setting (INPUT/Volume/MUTE/
Headphone) of the receiver.
—
No sound or
distorted sound
The sampling rate of a MP3 or WMA file
may not be compatible with the CD
player.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
24
Disc playback does
not start.
You may use a CD-R/RW that is not
finalized.
Finalize the CD-R/RW.
—
The disc label may not be facing up. Check that the disc label is facing up.
—
The disc may be defective. Try to play back another disc. If the same problem
does not happen, the disc you want to play back is
defective.
—
MP3/WMA disc may not contain
sufficient music tracks to be played back.
Check that your MP3/WMA disc contains at least 5
MP3/WMA music files.
—
The sampling rate of a MP3 or WMA file
may not be compatible with the CD
player.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
24
The USB device
cannot be
recognized.
Check that the USB device is connected
correctly.
Connect the USB device firmly.
11
Not linked with the
receiver
The system control cable is disconnected
from the system connector jack of the
receiver and/or the CD player.
Connect the receiver and the CD player with the
system control cable firmly.
9
Note
Status message Cause Remedy
See
page
NO USB
The USB device is not connected. Connect playable USB device.
11
OVER CURENT
Connected the USB device not playable
on this system.
Connected the USB device diagonally.
Disconnect the USB device. Change input source
other than USB and select USB an input source
again. Then connect playable USB device again.
—
To Next Page
Loading...
Need help?
General
