2
Table of Contents
1. Introduction ..................................................................................................................................... 3
2. Topics ............................................................................................................................................... 3
3. Basic Systems – Preparing CL/QL series and R series ................................................................ 4
3-1. Checking firmware versions and compatibility ......................................................................... 4
3-2. Unit ID settings .......................................................................................................................... 4
3-3. Unit ID Rules ............................................................................................................................. 7
4. Physical Connection and Redundancy .......................................................................................... 7
5. Managing IP addresses and connecting Dante Controller ........................................................ 10
5-1. Types of IP address for CL/QL and R series ............................................................................ 10
5-2. How to set an IP address for each port .................................................................................... 11
5-3. Direct Dante patching by mounting R series units .................................................................. 12
5-4. Dante patching by using Dante Controller .............................................................................. 13
6. Additional Design Tips .................................................................................................................. 14
6-1. Managing the Dante Network .................................................................................................. 14
6-2. Word clock and latency settings .............................................................................................. 14
6-3. Mixed Sampling Frequencies .................................................................................................. 16
6-4. Limits on the number of connectable Dante devices ............................................................... 17
6-5. Determine if a device can be remotely controlled ................................................................... 18
6-6. Possible device combinations for remote control .................................................................... 19
6-7. Controlling 3
rd
party I/O devices ............................................................................................. 20
History
March 2019 v1.0 released
All Yamaha products described in this document are the registered trademarks of Yamaha Corporation.
Also, other products described in this document are either the trademarks or the registered trademarks of each
manufacturer or party.
To Next Page
Loading...
Need help?
General
