4
3. Basic Systems – Preparing CL/QL series and R series
3-1. Checking firmware versions and compatibility
Before setting up a system, please check the version compatibility of each Dante device. If any device
with an incompatible version of firmware is used in the system, it may not get configured correctly, or
may have unexpected behavior. Remember that most devices have additional firmware files for their
Dante modules.
For the latest information and compatibility chart, visit the following page:
https://download.yamaha.com/files/tcm:39-1161321?_ga=2.7041458.1091912117.1544573794-
440072770.1543301352
3-2. Unit ID settings
Each CL/QL console and R series I/O rack relies upon a unit ID number for device recognition, remote
control functions and system management. It is important to set the ID numbers before constructing
a system. Understanding the scope of the ID numbers helps with system design.
Console ID
There can be up to four CL/QL consoles with a unique “Console ID” in a system. This ID number
determines what each console can do, and which settings will be shared with the R series devices in
the system. Find the Console ID in the DANTE SETUP menu.
Make sure:
・ version compatibility of all the devices in the system
・ version compatibility of each device and its built-in Dante module
To Next Page
Loading...
Need help?
General
