26
1A. CENTER SP
Choices: LARGE (LRG)/SMALL (SML)/NONE
Preset position: LRG
LRG: Select this position when your center speaker is
approximately the same size as the main speakers.
SML: Select this position when you use a center speaker
that is smaller than the main speakers. In this
position, low bass signals (below 90 Hz) at the center
channel are output from the SUBWOOFER terminals
(or the main speakers if the MAIN position is selected
on “1D. LFE/BASS OUT”).
NONE: Select this position when you do not have a center
speaker. The center channel sound will be output
from the left and right main speakers.
1B. REAR SP
Choices: LARGE/SMALL
Preset position: LARGE
LARGE: Select this position if your rear speakers have a high
ability for bass reproduction, or a subwoofer is
connected to the rear speaker in parallel.
In this position, full range signals are output from the
rear speakers.
SMALL: Select this position if your rear speakers do not have
a high ability for bass reproduction.
In this position, low bass signals (below 90 Hz) at the
rear channels are output from the SUBWOOFER
terminals (or the main speakers if the MAIN position
is selected on “1D. LFE/BASS OUT”).
SELECTING THE OUTPUT MODES SUITABLE FOR YOUR SPEAKER
SYSTEM (IN THE “SET MENU” MODE)
This unit provides you with the following functions to distribute respective output signals to suitable speakers in your audio system.
When speaker connections are all completed, select a proper position on each function to make the best use of your speaker
system.
* For details about the SET MENU mode, refer to pages 32 to 38.
1. SPEAKER SET
1A. CENTER SP
1B. REAR SP
1C. MAIN SP
1D. LFE/BASS OUT
1E. FRONT MIX
1F. MAIN LEVEL
ADJUSTMENTS BEFORE USING THIS UNIT
m DESCRIPTION OF EACH FUNCTION
To Next Page
Loading...
Need help?
General
