72
1 To clear a learned key function, press the LEARN button
using the point of a mechanical pencil, etc.
To clear a macro you made, press the MACRO button.
2 Press and hold the CLEAR button using the point of a
mechanical pencil, etc.
3 Holding the CLEAR button pressed, press and hold the
key whose function you want to clear until the indicator
flashes 3 times.
To clear two or more functions sequentially, do not
release the CLEAR button pressed, and repeat this step.
Note
If you clear a learned function of a key, the originally preset
function of the key is restored (except the keys which are
originally preset with no function.)
To Clear a Learned Function To Clear All Learned Functions
1 Select the kind of key functions all of which you want to
clear by using the MACRO switch on the side panel of
the remote control transmitter.
OFF: Select this position if you want to clear all of the
learned functions except macros.
QUICK: Select this position if you want to clear all of the
macros you made.
SLOW: Select this position if you want to clear all of the
learned functions including macros.
2 Press the CLEAR button using the point of a
mechanical pencil, etc.
* If one of the following operation is made after you press
the CLEAR button, the TRANSMIT/LEARN indicator
flashes rapidly and the current mode is canceled. If this
occurs, press the CLEAR button again.
• MACRO switch is switched to another position.
• Another key is pressed.
• There is no operation for about 30 seconds.
3 Press and hold the CLEAR button again. While holding
the CLEAR button pressed, press and hold the
MASTER VOLUME and keys simultaneously
until the indicator flashes 7 times.
To Next Page
Loading...
Need help?
General
