17
English
8 FRONT LEVEL +/– Keys
Increase (+) or decrease (–) the volume level of the front effect
speakers.
9 CENTER LEVEL +/– Keys
Increase (+) or decrease (–) the volume level of the center
speaker(s).
0 REAR LEVEL +/– Keys
Increase (+) or decrease (–) the volume level of the rear effect
speakers. Pressing these keys change both of the right and left
effect speaker’s levels at the same time with the level balance
between them unchanged. To change the level balance between
the right and left effect speakers, follow the instruction on page 33.
A RESET Button
Press this button to “reset” the internal microcomputer which
controls remote control operations. Microcomputer “reset” is
necessary when the remote control freezes. If you have
exchanged batteries in the remote control unit with new ones,
press the RESET button before using the remote control unit.
* Pressing the RESET button will not erase learned functions.
B ON SCREEN Display Key
Changes the type of display showing the program name and
parameters, or information for various setting changes and
adjustments on the connected monitor’s screen.
Whenever pressed, the screen changes to a full display, a simple
display and no display in turn.
C CLEAR Button
Used in USER or LEARN mode to erase a learned function. (See
page 65.)
D EFFECT ON/OFF Key
Normally ON, this key can be turned OFF to disable output
from the center and effect speakers so that the sound
becomes normal 2-channel stereo.
E Parameter Select Keys
Select DSP program parameters, or titles of the functions in the
SET MENU mode.
F MUTING Key
Decreases the master volume level by 20 dB. While muting, the
indicator on the master VOLUME control flashes on and off
continuously.
G Parameter +/– Keys
Edit DSP program parameters or used for setting changes and
adjustments in the SET MENU mode.
H MASTER VOLUME +/– Keys
Increase (+) or decrease (–) the master volume level.
I PARAMETER/SET MENU Switch
When set to the PARAMETER position, the Parameter Select
Keys and Parameter +/– Keys will select and edit DSP program
parameters. When set to the SET MENU position, the Parameter
Select Keys and Parameter +/– Keys are used for setting
changes and adjustments in the SET MENU mode.
J Program Select Keys (1 through 12)
Select DSP programs 1 through 12.
K Tuner Function Keys
Operate Yamaha tuner functions.
L Tape Deck Function Keys
Operate Yamaha tape deck functions.
M 1/2 Switch
When the YPC/USER/LEARN Switch is set to YPC, this switches
the CD/LD Function Keys to keys for use with either the CD
player or LD player. (“1” for the CD player and “2” for the LD
player.) When the YPC/USER/LEARN Switch is set to USER or
LEARN, this switch selects the group 1 or 2 of the learnable
function keys. (See page 64.)
To Next Page
Loading...
Need help?
General
