49
English
NOTE: Adjusting the master VOLUME, BASS, TREBLE controls,
etc., or selecting a sound field program has no effect on the material
being recorded.
NOTE: Composite video and S video signals pass independently
through this unit’s video circuits. Therefore, when recording or
dubbing video signals between two video cassette recorders, if your
source VCR is connected to provide only S video (or only composite
video) signals, you can record only a S video (or only a composite
video) signal on your second VCR.
NOTE: A source that is connected to this unit between digital jacks
only cannot be recorded by a tape deck or VCR other than the tape
deck connected to the OPTICAL TAPE 1 REC OUT jack of this unit.
NOTE: AC-3 RF audio input signal cannot be recorded by a tape
deck or VCR. To record an LD source, the LD player must be
connected to the OPTICAL digital audio signal input jack and/or
analog audio signal input jacks of this unit.
NOTE: Please check the copyright laws in your country to record
from records, compact discs, radio, etc. Recording of copyright
material may infringe copyright laws.
If you watch a video software that uses scramble or
encoded signals to prevent it from being dubbed, there may
be a case that display information superimposed on the
picture and/or the picture itself is disturbed due to those
signals.
SELECTING SOUND FIELD PROGRAMS
This unit has 12 programs for digital sound field processing, 6
from actual acoustic environments from around the world, and 6
programs for Audio/Video sources including sources encoded with
Dolby Pro Logic surround or Dolby Surround AC-3. Many of the
programs contain various parameters that can be adjusted to the
listener’s taste.
1. Set the PARAMETER/SET MENU switch on the remote control to
the PARAMETER position.
2. Select the desired sound field program by pressing the
PROGRAM selector on the front panel or by using the Program
Select keys on the remote control.
To Next Page
Loading...
Need help?
General
