Yamaha F40D - Page 17

Specifications and requirements
11
(50 HP@5500 r/min)
F50FET 36.8 kW@5500 r/min
(50 HP@5500 r/min)
F60CET 44.1 kW@5500 r/min
(60 HP@5500 r/min)
F70AET 51.5 kW@5800 r/min
(70 HP@5800 r/min)
FT50GET 36.8 kW@5500 r/min
(50 HP@5500 r/min)
FT60DET 44.1 kW@5500 r/min
(60 HP@5500 r/min)
Idle speed (in neutral):
750 50 r/min
Engine:
Type:
4-stroke L
Displacement:
996.0 cm
3
Bore  stroke:
65.0  75.0 mm (2.56  2.95 in)
Ignition system:
TCI
Spark plug (NGK):
F40DET DPR6EB-9
F40GET LKR7E
F50FED DPR6EB-9
F50FET DPR6EB-9
F60CET DPR6EB-9
F70AET LKR7E
FT50GET DPR6EB-9
FT60DET DPR6EB-9
Spark plug gap:
0.8–0.9 mm (0.031–0.035 in)
Control system:
Remote control
Starting system:
Electric starter
Starting carburetion system:
Electronic fuel injection
Valve clearance (cold engine) IN:
0.15–0.25 mm (0.0059–0.0098 in)
Valve clearance (cold engine) EX:
0.25–0.35 mm (0.0098–0.0138 in)
Min. cold cranking amps (CCA/EN):
430.0 A
Min. rated capacity (20HR/IEC):
70 Ah
Maximum generator output:
F40DET 16 A
F40GET 15 A
F50FED 16 A
F50FET 16 A
F60CET 16 A
F70AET 15 A
FT50GET 16 A
FT60DET 16 A
Drive unit:
Gear positions:
Forward-neutral-reverse
Gear ratio:
F40DET 1.85(24/13)
F40GET 2.33(28/12)
F50FED 1.85(24/13)
F50FET 1.85(24/13)
F60CET 1.85(24/13)
F70AET 2.33(28/12)
FT50GET 2.33(28/12)
FT60DET 2.33(28/12)
Trim and tilt system:
F40DET Power trim and tilt
F40GET Power trim and tilt
F50FED Hydro tilt
F50FET Power trim and tilt
F60CET Power trim and tilt
F70AET Power trim and tilt
FT50GET Power trim and tilt
FT60DET Power trim and tilt
Propeller mark:
F40DET G
F50FED G
F50FET G
F60CET G
6C1-9-79-1E0.book 11 ページ ２０１１年３月１７日 木曜日 午後２時５４分