Operation
61
EMU30880
Trolling
EMU30890
Adjusting trolling speed
The trolling speed on outboard motors
equipped with the variable trolling RPM
switches can be adjusted approximately 50
r/min with each press of a switch.
To increase the trolling speed, press the “ ”
switch.
To decrease the trolling speed, press the
“ ” switch.
The trolling speed changes approximately
50 r/min each time a switch is pressed.
If the trolling speed has been adjusted, the
engine returns to the normal trolling speed
when the engine is stopped and restarted
or when the engine speed exceeds ap-
proximately 3000 r/min.
EMU27821
Stopping engine
Before stopping the engine, first let it cool off
for a few minutes at idle or low speed. Stop-
ping the engine immediately after operating
at high speed is not recommended.
EMU38651
Procedure
1. Push and hold the engine stop button or
turn the main switch to “ ” (off).
2. After stopping the engine, disconnect
the fuel line if there is a fuel joint on the
outboard motor.
1. “ ” switch
2. “ ” switch
6C1-9-79-1E0.book 61 ページ ２０１１年３月１７日 木曜日 午後２時５４分
To Next Page
Loading...
