Yamaha F40D - Checks after Engine Warm up; Shifting; Stop Switches

Operation
59
if necessary. Consult your Yamaha
dealer if the cause for the low oil
pressure alert cannot be found.
[ECM01831]
EMU36531
Checks after engine warm up
EMU36541
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU36980
Stop switches
 Turn the main switch to “ ”, or press the
engine stop button and make sure the en-
gine stops.
 Confirm that removing the clip from the en-
gine shut-off switch stops the engine.
 Confirm that the engine cannot be started
with the clip removed from the engine
shut-off switch.
EMU34530
Shifting
WARNING
EWM00180
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
NOTICE
ECM01610
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the
engine, shift to neutral, then restart the
engine and allow it to warm up.
To shift out of neutral
1. Pull the neutral interlock trigger up (if
equipped).
2. Move the remote control lever / gear
shift lever firmly and crisply forward (for
forward gear) or backward (for reverse
gear) [about 35 (a detent can felt) for re-
mote control models]. Be sure to check
that the tilt lock lever is in the lock/down
position (if equipped) before operating in
reverse.
1. Neutral interlock trigger
ZMU03643
6C1-9-79-1E0.book 59 ページ ２０１１年３月１７日 木曜日 午後２時５４分