Operation
56
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
3. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
4. Place the throttle grip in the “ ”
(start) position. After the engine starts,
return the throttle to the fully closed po-
sition.
5. Turn the main switch to “ ” (start).
6. Immediately after the engine starts, re-
lease the main switch and allow it to re-
turn to “ ” (on). NOTICE: Never turn
the main switch to “ ” (start)
while the engine is running. Do not
keep the starter motor turning for
more than 5 seconds. If the starter
motor is turned continuously for
more than 5 seconds, the battery will
be quickly discharged, thus making it
impossible to start the engine. The
starter can also be damaged. If the
engine will not start after 5 seconds
of cranking, return the main switch to
“ ” (on), wait 10 seconds, then
crank the engine again.
[ECM00192]
When the engine is cold, it needs to be
warmed up. For further information, see
page 58.
6C1-9-79-1E0.book 56 ページ 2011年3月17日 木曜日 午後2時54分