Operation
52
2. Slightly tilt the outboard motor up to the
desired position using the power tilt
switch. WARNING! Using the power tilt
switch on the bottom cowling while
the boat is moving or engine is on
could increase the risk of falling over-
board and could distract the operator,
increasing the risk of collision with an-
other boat or an obstacle.
[EWM01961]
3. To return the outboard motor to the nor-
mal running position, press the power tilt
switch and slowly tilt the outboard motor
down.
EMU35392
Cruising in other conditions
Cruising in salt water
After operating in salt water, flush the cooling
water passages with fresh water to prevent
them from becoming clogged. Also rinse the
outside of the outboard motor with fresh wa-
ter.
Cruising in muddy, turbid, or acidic water
Water in some areas can be acidic or with a
lot of sediment in it, such as muddy or turbid
(cloudy) water. After operating in such water,
flush the cooling passages with fresh water to
prevent corrosion. Also rinse the outside of
the outboard motor with fresh water.
U60R79E0.book Page 52 Wednesday, December 18, 2013 1:32 PM
To Next Page
Loading...
