Yamaha F8C - Page 65

Maintenance
59
Fuel pump
Inspection or replace-
ment as necessary
Fuel/engine oil leakage Inspection
Gear oil Replacement
Greasing points Greasing
Clamp bracket bolt
(through tube)
Inspection and greas-
ing
Impeller/water pump
housing
Inspection or replace-
ment as necessary
Impeller/water pump
housing
Replacement
Power tilt unit Inspection
Propeller/propeller
nut/cotter pin
Inspection or replace-
ment as necessary
Shift link/shift cable
Inspection, adjust-
ment or replacement
as necessary
Spark plug(s)
Inspection or replace-
ment as necessary
Spark plug caps/spark
plug wires
Inspection or replace-
ment as necessary
Water from the cooling
water pilot hole
Inspection
Throttle link/throttle
cable/throttle pick-up
timing
Inspection, adjust-
ment or replacement
as necessary
Thermostat
Inspection or replace-
ment as necessary
Timing belt
Inspection or replace-
ment as necessary
Valve clearance
Inspection and adjust-
ment
Cooling water inlet Inspection
Main switch/stop
switch/choke switch
Inspection or replace-
ment as necessary
Wire harness connec-
tions/wire coupler con-
nections
Inspection or replace-
ment as necessary
Fuel tank (Yamaha por-
table tank)
Inspection and clean-
ing as necessary
Item Actions
Initial Every
20 hours
(3 months)
100 hours
(1 year)
300 hours
(3 years)
500 hours
(5 years)
U60R79E0.book Page 59 Wednesday, December 18, 2013 1:32 PM