3-45
GB
EMU01414
Power Tilt Model
WARNING
@
●
Be sure all people are clear of the out-
board motor when adjusting the tilt
angle, also be careful not to pinch any
body parts between the drive unit and
clamp bracket.
●
Use caution when trying a trim posi-
tion for the first time. Increase speed
gradually and watch for any signs of
instability or control problems.
Improper trim angle can cause loss of
control.
●
Use the power tilt switch located on
the bottom engine cowling (if
equipped) only when the boat is at a
complete stop with the engine off.
@
1) Place the gear-shift lever in the neutral
position.
2) Tilt the engine to the desired angle
using the power tilt switch.
NOTE:
@
Stay within the trim operating angle when
trimming the outboard motor using the
power tilt system.
@
To raise the bow (“trim-out”), tilt the engine
up.
To lower the bow (“trim-in”), tilt the engine
down.
Make test runs with the trim set to different
angles to find the position that works best for
your boat and operating conditions.
U68T73A0.book Page 45 Sunday, March 30, 2003 6:34 PM
To Next Page
Loading...
